CRITICAL STATE SELECTION OF THE DYNAMIC HORIZONTAL IMPACT TEST FOR A CERTAIN TYPE AIRLINE SEAT INSTALLED

HUANG WanJia; HAN Liang

doi:10.16579/j.issn.1001.9669.2016.03.043

您当前的位置：

首页 >

文章列表页 >

CRITICAL STATE SELECTION OF THE DYNAMIC HORIZONTAL IMPACT TEST FOR A CERTAIN TYPE AIRLINE SEAT INSTALLED

更新时间：2022-09-22

- CRITICAL STATE SELECTION OF THE DYNAMIC HORIZONTAL IMPACT TEST FOR A CERTAIN TYPE AIRLINE SEAT INSTALLED
- Journal of Mechanical Strength Vol. 38, Issue 3, Pages: 662-666(2016)
- 作者机构：
  
  1. 中航通飞研究院有限公司
- 作者简介：
- 基金信息：
- DOI：10.16579/j.issn.1001.9669.2016.03.043
  CLC：
扫描看全文
HUANG WanJia, HAN Liang. CRITICAL STATE SELECTION OF THE DYNAMIC HORIZONTAL IMPACT TEST FOR A CERTAIN TYPE AIRLINE SEAT INSTALLED. [J]. 38(3):662-666(2016)
DOI：

HUANG WanJia, HAN Liang. CRITICAL STATE SELECTION OF THE DYNAMIC HORIZONTAL IMPACT TEST FOR A CERTAIN TYPE AIRLINE SEAT INSTALLED. [J]. 38(3):662-666(2016) DOI： 10.16579/j.issn.1001.9669.2016.03.043.

摘要

针对某型通用飞机飞行员座椅/约束系统水平动态冲击试验中临界状态的选择问题,通过仿真模拟及试验验证相结合的方式对座椅动态冲击试验的临界状态进行选取,同时验证其在最危险的状态下也能满足适航的安全性要求。通过试验验证表明,仿真分析较好地模拟了装机动态水平冲击试验,为以后的相关研究工作打下基础。

Abstract

According to the critical state selection issue of horizontal dynamic impact test in the pilot’s seat / restraint system for a certain type of general aviation aircraft. The critical state is selected through simulation analysis and test in the seat’s dynamic impact test,while the critical state is also validated by both simulation and test to ensure it can meet the safety requirements of airworthiness. The simulation analysis shows a consistency compared with the test on horizontal dynamic impact test,and this laid a foundation for future research works.

关键词

座椅/约束系统动态水平冲击仿真验证

Keywords

Seat / Restraint systemHorizontal dynamic impact testsSimulationVerify

references

Views

126

下载量

CSCD

Alert me when the article has been cited

提交

Tools

Publicity Resources

SIMULATION AND EXPERIMENTAL STUDY ON STRENGTH AND FATIGUE PERFORMANCE OF A SUV FRONT SUBFRAME (MT)

BIONIC DESIGN OF THE MOVING JOINTS FOR GECKO BASED ON LINKAGE CONFIGURATION (MT)

GEOMETRIC PARAMETERS DETERMINATION AND SIMULATION OF SMALL-SIZED RV REDUCER

STUDY ON CRACK GROWTH OF AN ENGINE TURBINE

UNDERCUT AND TOOTH PROFILE MODIFICATION OF DOUBLE HELICAL PULLEY

Related Author

No data

Related Institution

School of Mechanical Engineering, Liaoning Technical University

School of Mechanical Engineering, Xijing University

School of Mechanical Engineering, Hubei University of Technology

AECC Hunan Aviation Powerplant Research Institute

College of Electrical Engineering,Harbin Institute of Technology

⁰