CONTACT ANALYSIS OF THE SPIRAL BEVEL GEAR BASED ON MATLAB

DONG ShuJing

doi:10.16579/j.issn.1001.9669.2016.02.035

您当前的位置：

首页 >

文章列表页 >

CONTACT ANALYSIS OF THE SPIRAL BEVEL GEAR BASED ON MATLAB

更新时间：2022-09-22

- CONTACT ANALYSIS OF THE SPIRAL BEVEL GEAR BASED ON MATLAB
- Journal of Mechanical Strength Vol. 38, Issue 2, Pages: 410-413(2016)
- 作者机构：
  
  1. 大连科技学院机械工程系
- 作者简介：
- 基金信息：
- DOI：10.16579/j.issn.1001.9669.2016.02.035
  CLC：
扫描看全文
DONG ShuJing. CONTACT ANALYSIS OF THE SPIRAL BEVEL GEAR BASED ON MATLAB. [J]. 38(2):410-413(2016)
DOI：

DONG ShuJing. CONTACT ANALYSIS OF THE SPIRAL BEVEL GEAR BASED ON MATLAB. [J]. 38(2):410-413(2016) DOI： 10.16579/j.issn.1001.9669.2016.02.035.

摘要

利用局部综合法,通过Matlab编程实现了一对弧齿锥齿轮的齿面接触分析(TCA),分别确定出轮齿中点、大端和小端齿面上的接触迹线的形状和传动误差曲线图,并对所得到的曲线图进行了分析和解释,不仅改进了直接利用TCA方法编程求解轮齿接触时,编程复杂、耗时多等不足,而且为弧齿锥齿轮切削参数的合理设计奠定了良好的基础。

Abstract

In this paper,the use of local synthesis method,study the tooth contact analysis（ TCA） of the CRH5 traction gear by programming with MATLAB,respectively,calculate contact tracing line on the tooth surface and the graph of the transmission error of the middle point,huge end and small end respectively,and the graph is analyzed and explained,not only improves the direct use of TCA method to solve tooth contact,such as programming complex,time-consuming,and laid a good foundation for the rational design of cutting parameters of the spiral bevel gears.

关键词

弧齿锥齿轮接触分析传动误差

Keywords

Spiral Bevel GearContact analysisTransmission Error

references

Views

310

下载量

CSCD

Alert me when the article has been cited

提交

Tools

Publicity Resources

INFLUENCE OF ACTIVE MODIFICATION PARAMETERS ON BEARING CHARACTERISTICS OF OPPOSITE GEAR PAIRS (MT)

SIMULATION AND ANALYSIS OF COMPOUND ABRASIVE GRINDING PERFORMANCE OF SPIRAL BEVEL GEARS (MT)

VIRTUAL MANUFACTURING AND SIMULATION ANALYSIS OF SPIRAL BEVEL GEAR BASED ON CURVATURE ADJUSTMENT

VIRTUAL MACHINING AND FINITE ELEMENT ANALYSIS OF SPIRAL BEVEL GEAR

RESEARCH ON ELASTIC MESHING EFFECT OF RV DRIVE WITH BEVELOID GEAR

Related Author

No data

Related Institution

College of Mechanical Engineering, Xi′an University of Science and Technology

Beijing Nuclear Chemical Research and Design Institute, China Nuclear Power Engineering Co., Ltd.

School of Mechanical and Electrical Engineering, Lanzhou University of Technology

Qinghai Huading Gearbox Co., Ltd.

School of Mechanical Engineering, University of Shanghai for Science and Technology

⁰